Adafruit Cable Usb A Serial Ttl, Silabs Cp2012 Debug Console

Descripción

****************** COLDFIRE ELECTRONICA *******************



---->> PRODUCTO COMPLETAMENTE NUEVO, SELLADO EN SU EMPAQUE.



The cable is easiest way ever to connect to your Microcontroller / Raspberry Pi / Bluetooth Module / Xbee Module / WiFi Router / to serial console port.

Inside the big USB plug is a USB<->Serial conversion chip and at the end of the 36" cable are four wire - red power, black ground, white RX into USB port, and green TX out of the USB port. The power pin provides the 5V @ 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.

Because of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi or BeagleBone Black. Connect the pins as shown to power the Pi or BBB and establish the RX/TX link.

This cable have the SiLabs CP2012 chipset instead of Prolific. SiLabs chips seem to have better driver stability, and can handle very high speeds and 'unusual' non-standard baud rates.


Also handy for hacking WiFi routers to install alternate OS's, or nearly any other 3.3V logic serial port. This is easier to use than an FTDI cable in many cases because the wires are separated. Note that we call this a "TTL cable" (since that's what they're called) but technically it's CMOS logic.

This cable is not good for Arduino re-programming such as a Boarduino, MENTA, Monochron, etc. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence. For that we suggest an FTDI cable or FTDI friend.



* Compatible con: Windows 7/8/10/11, MAC OS X, Linux.

Garantía del vendedor: 30 días